- This topic has 3 replies, 1 voice, and was last updated 2 years, 9 months ago by .
- You must be logged in to reply to this topic.
Here are some specs that I’ve collected as I put a few ZR3 motor together.
.008 – .010 crank end play
.006 – .009 valve lash
Timing .400 – .650
Ring gap is .004 -.0045 per inch bore
Head studs 150inch pounds
Rod bolts (arp) 150 inch pounds
Use a lite coat of Toyota sealer/silicone on the head gasket (JR race car sells it)
What are some other tips or specs you guys use?
I’m working to build an engine building worksheet to keep all your specs and notes for each build. I’ll share it once it’s finished.
2005 Halfscale ZR3 Shockwave 8.90
2005 Halfscale ZR3 Shockwave 8.90
2005 Halfscale ZR3 Shockwave 8.90
2005 Halfscale ZR3 Shockwave 8.90
Started by: Jeremy Blanchard
in: General
Started by: Tyler Snowden
in: Chassis
Started by: Wade Metzinger
in: Engine
Started by: Scott Tipps
in: Carb
Started by: Redneckracer
in: Clutch
Started by: Brent Catalanotto
in: Engine
Started by: Rob Butler
in: General
Started by: Cory Selleck
in: General
Started by: Keith Zimmer
in: Clutch
Started by: Robert Hamilton
in: Engine
Started by: Robert Hamilton
in: General
Started by: Todd Shaul
in: General
Started by: Mike Holland
in: For Sale